Advertisement
DISASSEMBLY
(8)
Replacement of spindle motor
a
Remove
the two screw (Y13) which hold escutcheon
mecha cover (see exploded view, Ref no 15, 16 of page
30.)
b Remove the two screw ( 11 ) then, after removing the
upper pulley, universal pulley and spring.
c
Loosen screw ( 12 ) which hold tarntable.
d Remove the two screw ( 13) and then replace the spindle
motor.
e
After fixed the spindle motor, set the turntable upper
surface so that ti is 4mm + 0.1mm above the chassis.
f With the smaller diameter end of the spring coil upward,
install the universal pulley and upper pulley, and then
secure by using the two screws ( 11 ) for holding the
supper pulley.
TURN
TABLE
SPINDLE MOTOR
(9)
Replacement of sled motor and belt
a
Remove the screw and spring plate with flat gear.
b Remove the screw ( 15) which hold worm gear.
c
Remove
the two screw ( 16 ) which hold sled motor
bracket.
Remove the two screw ( 17) which hold sled motor.
e
Replace the sled motor and belt.
(10)
Replacement of pick-up
a
Remove the screw and springplate with flat gear.
b Remove the screw ( 14 ) and spring plate.
c
Replace the pick-up.
11
& PULLEY
CD rier
jen
COIL
ER)
TABLE
—"
&
AP
R
ZA
{>
FAAN2
SS
13
me
?
S
ZN
a
AZ
a
~ al
=e J) SPINDLE
MOTOR
@15
Lp
voces
a
oe
as
@14
Gy sPRING
PLATE
A
Advertisement
