Table of Contents
Advertisement
Issue
All LEDs light up or
flash.
UP appears on the
display.
Water is left in the
appliance at the end
of the program.
Appliance cannot be
switched on or oper-
ated.
Appliance does not
start.
Cause and troubleshooting
Electronics have detected a fault.
Press the main switch button for approx. 4 sec-
1.
onds.
→ "Controls", Page 11
The appliance is reset and restarted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Unplug the power plug or switch off the cir-
‒
cuit breaker in the fuse box.
Wait at least 2 minutes.
‒
Switch on the circuit breaker in the fuse box
‒
or plug in the power plug.
Switch on the appliance.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service", Page 49
A software update is available.
Press the remote start button to install the soft-
▶
ware update.
a After a successful software update, "Suc" ap-
pears on the display for a few seconds.
Filter system or area under the filters is blocked.
Clean the Filters → Page 34 .
1.
Clean the Drain pump → Page 47 .
2.
Program has not yet ended.
Wait until the program ends or terminate the
▶
program with Reset.
→ "Terminating the wash cycle", Page 27
▶
Software update is taking place.
Wait until the software update has finished.
▶
Appliance functions have failed.
Pull out the power cord plug or switch off the
1.
breaker.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
The breaker has tripped.
Check the relevant breaker.
▶
Power cord is not inserted.
Check whether the power outlet is working.
1.
Troubleshooting en-us
45
Advertisement
Table of Contents
