Table of Contents
Advertisement
¡ You can only change a cycle in
progress if you can cancel it
first.
→ "Terminating the wash cy-
cle", Page 27
¡ To save energy, the appliance
switches off automatically
10 minutes after the end of the
wash cycle. If you open the ap-
pliance door immediately after
the wash cycle has ended, the
appliance will switch off after 4
seconds.
12.7 Activating the button
lock
The button lock prevents the ap-
pliance from being operated acci-
dentally or incorrectly while run-
ning.
Press
for approx. 3 sec-
▶
onds.
a The button lock is activated and
will be automatically deacti-
vated at the end of the cycle.
flashes on the display
a
when the appliance is running.
a The button lock remains acti-
vated with a power failure.
12.8 Deactivating the
button lock
Press
for approx. 3 sec-
▶
onds.
12.9 Interrupting the wash
cycle
Press On/Off.
1.
The program is saved and the
appliance switches off.
Press On/Off.
2.
Press
to resume the wash
3.
cycle.
Basic Operation en-us
12.10 Terminating the
wash cycle
To end a cycle early or to switch
from one that has already started,
you will need to cancel it first.
Press
▶
4 seconds.
a All displays light up.
a As soon as the displays are off,
the display shows "0h:01m"
and the residual water is
pumped out.
a The cycle is cancelled and
ends after approx. 1 minute.
12.11 Switching off the
appliance
CAUTION
To avoid risk of injury, always use
caution when opening the door
during or following a wash cycle
as hot water or steam may es-
cape.
Do not fully open the door until
▶
water noises have stopped and
steam has subsided.
Please note the information on
1.
Preventing Material Damage
→ Page 9 .
Press On/Off.
2.
for approx.
27
Advertisement
Table of Contents
