Cleaning - Prizmatix Optogenetics-LED User Manual

Prizmatix
6. Push the back-panel power switch to the "ON" position, and then Press the green
button on front panel to turn the LED on (the internal green light of the button is
turned on too). Turn the dial of the potentiometer clockwise. The LED light should
be seen at the ferrule on the 500um fiber.
CAUTION!
Do not stare at operating lamp. May be harmful to the eyes
:
7. LED power can be adjusted using the 10-turn potentiometer on front panel.
8. Press the green button once again, the LED is turned off (as indicated by the button
light). Make sure to turn the unit off by switching the Power Switch on back panel
before disconnecting from power supply.
9. For TTL input connect BNC cable to TTL input connector on back of unit. To enable
TTL control change the position of the TTL Int/Ext switch to Ext position.
10. For Analog Input connect BNC cable to Ain input connector on back of unit. To
enable Analog Input control change the position of the Ain Int/Ext switch to Ext
position
CAUTION!:
Do not use the illuminator without the Optical Fiber
connected to SMA port!
CAUTION!:
Do not cover back panel of unit - ensure that air can circulate
freely.

3.5 Cleaning

Keep the connector port clear from dirt and do not leave it open. Make sure to close the
SMA port with the chained cap when the fiber is not connected.
CAUTION!:
Do not try to clean inside the port – you may damage the
illuminator!
The box can be wiped with mild wet-wipes.
CAUTION!:
Do not attempt to use chemicals, e.g. Alcohol or Acetone –
you may damage plastic components
9 | P a g e Optogenetics-LED User Manual