Battery Replacement - Fisher-Price DC BATWHEELS Launch & Race Betcave Manual

Locate the battery door on the back of
the computer.
Loosen the screw in the battery door
and remove the door.
Remove exhausted batteries and
properly dispose. Insert three AAA
(LR03) alkaline batteries.
Replace the battery door and tighten
the screw. Do not over-tighten.
If this toy begins to operate erratically,
you may need to reset the electronics.
Remove the batteries and reinstall
them.
When sounds or lights become faint or
stop, it's time for an adult to change
the batteries.
Protect the environment by not
disposing of this product or any
batteries with household waste. This
symbol indicates that this product
shall not be treated as household
waste. Check your local authority for
recycling advice and facilities.

BATTERY REPLACEMENT

Battery Safety Information
In exceptional circumstances, batteries
may leak fluids that can cause
a chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries
or batteries of different types:
alkaline, standard (carbon-zinc) or
rechargeable.
• Insert batteries as indicated inside
the battery compartment (+/-).
• Remove batteries during long
periods of non-use. Always remove
exhausted batteries from the
product. Dispose of batteries safely.
Do not dispose of this product in a
fire. The batteries inside may explode
or leak.
• Never short-circuit the battery
terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the product before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following
two conditions: (1) this device may
not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
L'utilisation de ce dispositif est
autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire
de brouillage et (2) il doit pouvoir
tolérer tout brouillage radioélectrique
reçu, même si ce brouillage est
susceptible de compromettre son
fonctionnement.
19