Table of Contents
Advertisement
6 Maintenance
6
Maintenance
6.1
Introduction
Operational failures due to inadequate or improper maintenance can cause very high
repair costs and long downtimes. The operational safety and service life of this system
depend on proper maintenance, as well as several other factors.
Because of the different operating conditions, it is not possible to specify in advance how
often it is necessary to check for wear, or carry out inspections, maintenance and repair.
Suitable inspection intervals must be drawn up which take the individual operating
conditions into account.
A lack of maintenance or improper maintenance can cause injury and damage to equip-
ment!
Closures on covers, doors, etc. must not be altered under any circumstances. Safety
devices must not be removed or bypassed.
When welding in or near the equipment, the earth terminal needs to be attached adja-
cent to the welding area so that no current can flow uncontrolled over the bearings and
electrical components.
During maintenance, cleaning, and repair work the power must be cut off to all actuators
and secured against unintentional switching on.
The master switch on the control cabinet must be shut off and secured.
The staff responsible for carrying out this work must be personally satisfied that all
drives are secured against switching on unintentionally.
Schmid AG energy solutions cannot honour warranty claims resulting from damage
caused by insufficient maintenance.
6.2
Maintenance contract
In order to prevent faults and defects to the system, and to ensure optimal combustion,
we recommend maintenance of the system by Schmid AG energy solutions either annu-
ally or every 4000 hours of operation. The operating hours can be read off from the touch
panel of the control unit.
Schmid AG energy solutions offers maintenance contracts with different performance
levels. Request an offer through our customer service department.
Schmid AG energy solutions cannot honour warranty claims resulting from damage
caused by insufficient maintenance.
D-50
WARNING!
i
Underfeed grate UTSK
1.10 en
Advertisement
Table of Contents
