Extel XV250 Quick Start Manual

XV250
EN
ELECTRIC GATE
V1
OPENER KIT
With cylinders - For swing gates
Ref. 761003
Thank you for purchasing an EXTEL automatic gate opener.
This document is a quick start guide detailing the main installation steps as well as the equipment required. To perform the installation, please
download the installation manual at the following address:
Warning: The safety instructions and installation instructions can be found in the installation manual. Follow all these instructions, as an as
incorrect installation can cause serious injuries.

1. DESCRIPTION

1
x 2
6 7
x 2 x 1
1 Actuators
2 Switchgear
3 Flashing light and its screws
4 Photocells and their screws
5 Remote control

2. EQUIPMENT REQUIRED (NOT SUPPLIED)

The tools and screws required for the installation must be in good condition and compliant with applicable safety standards.
Please use screws compatible with the bracket to which the motors will be attached (e.g. anchoring studs, threaded rod with chemical seal, etc.)
Flashing light
3m cable
2 x 0.5mm
or swing gates
www.avidsen.com
2 3
x 1 x 1
8 9
x 1 x 2
6 Installation template
7 Backup fuses
8 Accessories for the solar kit
9 Gate mounting bracket
10 Post mounting bracket
1 fl at head screwdriver
1 drill 1 Phillips screwdriver
Motor Photocells
8m cable 10m cable
2 2 x 1.5mm 2 4 x 6/10
3 3
4
x 2 x 2
x 1
10 11
x 2 x 1
1 pencil
1 spirit level 1 measuring tape
Attaching the
Attaching the motors
onto the posts
brackets
on the gate:
Choose a screw/nut system
compatible with the
thickness of the gate.
There are 4 attachment
points
5
4 4 4
x 2
x 6 x 6 x 4
12 14
x 2 x 2
13
x 2
11
Override key
12 Pin
13 Pin axis
14 Locking nut