Trouble Shooting - FSP Technology EnerX 3000 User Manual

TROUBLE SHOOTING

Warning and Fault List
Code Type Code #
Fault F01
Fault F02
Fault F03
Fault F04
Fault F05
Fault F06
Fault F07
Fault F08
Fault F09
Fault F10
Fault F11
Fault F12
Fault F13
Fault F14
Warning W01
Warning W02
Warning W03
Warning W04
Warning W05
Warning W06
Phenomenon and/or Possible cause
No response while press the main switch.
No Utility power and PV is applied.
No response while pressing the main switch.
Utility power or PV power exists.
Output turned off, Buzzer beeps continuously, RED LED solid on
F01 shows. Fans abnormal stopped during startup
sequence
F02 shows.
F03 shows.
F04 shows. Battery voltage dropped to an extremely
low level
Event Code Type
Fan fault Fault
High PV-volt Fault
High bat-volt Fault
Low bat-volt Fault
Output S.C. Fault
High op-volt Fault
Low op-volt Fault
High bus-volt Fault
Low bus-volt Fault
High PV-amp Fault
High inv-amp Fault
High bus-amp Fault
High disc-amp Fault
Over temp. Fault
Grid not exist Warning
PV not exist Warning
Pack not exist Warning
Weak SoC Warning
Weak PV-volt Warning
Power de-rate Warning
What to do
Check whether the DC breaker tripped or has not yet
turned on?
If problem exist still, please contact the service center
to repair it.
Check whether the AC breaker tripped? Or PV voltage
reaches to the operation level?
If problem exist still, please contact the service center
to repair it.
Please contact service center to replace them.
Configure the PV panels lower than 450V.
Disconnect the Utility and PV power. Then, re-apply
again. If over-voltage alarm still, suppose the internal
charger with some problem, please contact with
service center to repair it.
Please contact the service center to check if battery
still in warranty period.
24
Code # Event
F15 Bus start fault
F16 Inv start fault
F17 High dc offset
F18 Over-load
F19 Amp sense fault
F20 Backfeed fault
F21 Firmware fault
F22 Par-CAN fault
F23 Par-host fault
F24 Par-sync fault
F25 Par-bat fault
F26 Par-grid fault
F27 Par-opa fault
F28 Par-set fault
W07 Heavy load
W08 Temp issue
W09 Fan issue
W10 BMS lost
W11 Comm. Lost
W12 Par limited