AC Output Connection
CAUTION: If signal unit operation, please close the cover of parallel socket to reduce risk of electric shock.
Plug AC power cord on the AC output socket.
Output powered when the main switch on the front panel pressed for 3 sec.
In case the load rating higher than the socket could support (>13Amp), please connect the power cable on
the AC output terminal block. Before doing that, please be sure the unit is "OFF" completely.
1. Remove insulation sleeve 10mm for three conductors. And shorten phase L and neutral conductor N 3
mm.
2.
Insert AC output wires according to polarities indicated on terminal block and tighten the terminal
screws. Be sure to connect PE protective conductor (G) first.
3.
Make sure the wires are securely connected and then knock terminal cover to install cable gland.
4.
Insert the terminal cable to cable gland, and install cover box on rear panel.
CAUTION: Important
Please install the terminal cover firmly
o reduce risk of electric shock
t
9