Wisdom S10P Owner's Manual

Small footprint 500w powered subwoofer

Advertisement

Quick Links

Owner's Manual
S10P
Small Footprint 500W Powered Subwoofer

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S10P and is the answer not in the manual?

Questions and answers

Summary of Contents for Wisdom S10P

  • Page 1 Owner’s Manual S10P Small Footprint 500W Powered Subwoofer...
  • Page 2: Table Of Contents

    DOCUMENT CONVENTIONS This document contains general safety, installation, and operation instructions for the Wisdom Audio S10P Small Imprint Subwoofer. It is important to read this document before attempting to use this product. Pay particular attention to: WARNING: Calls attention to a procedure, practice, condition or the like that, if not correctly performed or adhered to, could result in injury or death.
  • Page 3: Safety

    Safety FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
  • Page 4: Introduction

    The ultra-compact design also lends itself to multi- subwoofer layouts for improved bass performance. At only 7.6" (193mm) deep, including power cable, the stylish S10P is discreet and easy to install. Its versatility and flexibility are increased through the use of 3 summing stereo input options, XLR, RCA, and ¼"...
  • Page 5: Rear Panel Features

    Rear Panel Features Welcome 1 Power Mode: Select either AUTO or ON (always-on) power mode. • Auto: Amp turns on when signal is detected. It goes into standby after 20 minutes with no input signal.* • On: Amp is always on, regardless of input signal status. Once audio signal is detected, the amp will automatically turn on in typically one second or less.
  • Page 6: Setting Up Your S10P

    Setting Up your S10P The S10P is setup to work with any standard AV Receiver or Surround Preamp/Processor when using the “LFE” or “Subwoofer” outputs. It will reproduce the low frequency effects and any audio from bass management of the processor to which it is connected (assuming speaker settings within the processor are set to small).
  • Page 7: Dsp Control Via Rear Panel (User Level)

    DSP Control Via Rear Panel (User Level) Activate the rear-panel Feature Menu by pressing the Feature Control knob. “VOLUME” is the default Feature displayed after power up. The Feature Menu will time-out after approximately 3 minutes of inactivity. Rotate the knob to Step through the Features listed below.
  • Page 8: Up/Down-Firing Setup

    Up/Down-Firing Setup The small footprint of the S10P allows it to be used effectively in many situations where a more conventional “bass cube” would be either cumbersome or impossible. Examples include locating it behind a couch, in the small space between a couch and wall, lying flat under a set of risers, under a couch/table, within a cabinet, or beneath a bed.
  • Page 9: Placement And Installation

    4. Attach the gaskets to the 4 metal spacers (included in the accessories) by peeling the backing from the gaskets and pressing them onto the two sides. Use care to center the gaskets. 5. Install the four feet with the four metal spacers onto the surface that will now become the bottom of the subwoofer.
  • Page 10: Cleaning And Care

    Do not apply any liquids directly onto the cabinet or the rear- panel electronics. Do not use any liquids for cleaning the rear-panel electronics. Your S10P subwoofer is maintenance-free. However, care should be taken to avoid placing your subwoofer in direct sunlight or near any heat sources. Ensure all electrical cables are secured and don’t present a tripping hazard.
  • Page 11: North American Warranty

    The warranty will not apply to any Wisdom Audio product that has been misused, abused, altered, or installed and calibrated by anyone other than an authorized Wisdom Audio dealer.
  • Page 12: Obtaining Service

    Wisdom Audio for further service information or parts, or to obtain a Return Authorization. The Wisdom Audio Service Department works closely with your dealer to solve your service needs expediently.
  • Page 13: Specifications

    IEC 60320 C18 • Shipping Weight 50 lbs (23Kg) • Shipping Dimensions 21.25" x 20.25" x 12.5" (54cm x51.4cm x 31.8cm) Allow additional 0.8" (35mm) for power cord and input wiring For more information, see your Wisdom Audio dealer or contact: info@wisdomaudio.com...
  • Page 14 WISDOM and the stylized W are registered trademarks of Wisdom Audio. Wisdom Audio
1572 College Parkway, Suite 164 Carson City, Nevada 89706 USA (775) 887-8850 (775) 887-8820 wisdomaudio.com S10P OM RevB © 1/2024 Wisdom Audio, Inc. All rights reserved. Printed in U.S.A.

Table of Contents