Table of Contents
Advertisement
the
symbol).
The cooking zone display shows the number of
the setting currently being modified (1 =
Automatic controls lock, 2 = Showroom, 3 =
ECO-logic) with its setting at the side (
activated,
: deactivated).
For example,
automatic controls Lock is deactivated.
Press the Increase
to change the settings to
ECO-logic parameter is modified you can
select the following values
kW),
(maximum power draw).
To change the subsequent settings, press the
Controls lock button
If the hob is already installed and in use,
cut the power supply to the hob. Switch
the power back on and proceed as
indicated above within two minutes.
Advice on energy-saving
The diameter of the base of the pan must
correspond to the diameter of the cooking zone.
• When buying a pot, check whether the
diameter indicated is that of the base or the
top,
as the top is almost always larger than the base.
• The base of the cookware must be thick and
completely flat. In addition, the hob should
be clean and dry as well.
• When preparing dishes with long cooking
times, you can save time and energy by
using a pressure cooker, which also makes it
possible to preserve the vitamins in the food.
• Make sure that the pressure cooker contains
enough liquid as, if there is not enough and
it overheats, this may cause damage to both
the pressure cooker and the cooking zone.
• If possible, always cover the pans with a
suitable lid.
91477A870/A
:
indicates that the
or Decrease
buttons
or
. If the
(3 kW),
.
• Choose a pan suitable for the quantity of
food to be cooked. A large, half-empty
saucepan leads to a waste of energy.
• Do not use cast-iron cookware or cookware
with a rough base.
If hob and oven are being used at the
same time, under certain conditions the
maximum power limit that can be used
by your electrical system might be
exceeded.
(4
USE - 31
Advertisement
Table of Contents
