Page 1
SMEG S.p.A. Via Leonardo da Vinci, 4 42016 GUASTALLA - ITALIA COD.
Page 2
DESCRIPTION OF THE HOT PLATES 1 Normal plate Ø 145 2 Normal plate Ø 180 7 Control knob for electric plate n° 1 8 Control knob for electric plate n° 2 13 Warning light indicating that one or more plates are operating TYPE: PAZ 04 of 1000 W of 1500 W...
Page 3
1) SWITCHING ON THE ELECTRIC PLATES The hobs may be equipped with three types of electric plates: normal, thermostat and rapid plates indicated by a red mark. The normal plates and the rapid plates are controlled by a 7 - position switch (see fig.
Page 4
WARNINGS: When the plate is switched on for the first time, or if it has remained unused for a long period, it should be dried for 30 minutes on switch position n° 1. This will eliminate any moisture that may have been absorbed by the insulating material.
Page 5
IMPORTANT: Always disconnect the appliance from the electricity main before carrying out any cleaning operation. 3) HOTPLATE If you want to preserve the surface clean and bright, periodically wash the hot plate with lukewarm soapy water. Following this, all parts should be thoroughly rinsed and dried.
Installation and maintenance must only be carried out by a qualified installer. Incorrect installation could cause damage to persons, animals and property for which the manufacturer cannot be held responsible. 4) INSTALLING THE HOT PLATE Check that the appliance is in a good condition after having removed the outer packaging and internal wrappings from around the various loose parts.
6) ELECTRICAL CONNECTIONS Electrical connection must be carried out in compliance with the specifications and provisions in force. Before proceeding with the connections, check that: - The voltage rating of the appliance and the current sockets suits the maximum power draw of the appliance (see data label affixed to the lower part of the appliance itself).
Page 8
Disconnect the appliance from the mains supply prior to any conversions being carried out. 7) CHANGING THE TYPE OF POWER SUPPLY Although they leave our factory preset for single- phase connection, certain appliances may by converted to the threephase system. Comply with the following instructions: a) Remove the hotplate from the top of the cabinet, overturn it, unscrew screw "Z"...
Page 9
Always disconnect the appliance from the electricity main before proceeding with any servicing operation. 8) REPLACING THE ELECTRICAL COMPONENTS For access to the various parts, remove the hotplate from the top of the cabinet. Then overturn it, unscrew screw “Z” and remove under part. (see fig. 9). After these actions is possible to work on the plates, commutators, clamps and input cable.
TECHNICAL ASSISTANCE AND SPARE PARTS This appliance, before leaving the factory, has been carefully tested and regulated by expert and specialized personnel in order to guarantee the best performances. Any repairs or adjustments which may be subsequently required may only be carried out by qualified personnel with the utmost care and attention.