Table of Contents
Advertisement
5
Insert the two side bare wire ends into the left
and the right terminal block openings.
Tighten the 3 screws securely into the
terminal block. (approximately 35 - 50 IN-LB)
Black
a
White
b
Red
c
Terminal Block
d
Wire Ends
e
Ground Strap
f
Conduit Connection Plate
g
Ground Screw
h
Ground Wire
i
Bend strap up and attach.
j
Optional Rear Filler
Installing the Rear Filler
If the counter does not bridge the opening at the
rear wall, the rear filler kit that is provided with the
slide-in range will be needed.
NOTE
• If the countertop depth is greater than 25 3/8"
there will be a gap between the filler kit and the
back wall.
• If the countertop depth is less than 24 3/4", the
control panel will not sit flush with the
countertop.
1
Using a screwdriver, remove the three screws
holding the rear bracket
Vent Trim
a
Rear Bracket
b
2
Attach the rear bracket
assembly as shown, using the three screws
removed in step 1.
Rear Filler
c
Anti-tip Device
Installing the Anti-tip Device
Tip Hazard
WARNING
• A child or adult can tip the range and be killed.
• Install the anti-tip device to the structure and/or
the range. Verify the anti-tip device has been
properly installed and engaged by following the
guide on the anti-tip bracket template.
INSTALLATION
21
in place.
b
and filler
b
c
Advertisement
Table of Contents
