Advertisement
6)
Cut Cable Ties and Fasten Two Hex Head Screws and Two Washers
a. Cut and fully remove the two cable ties. Do not leave any portion of the cable ties in between the rear
housing and motor bracket.
b. Hand-tighten two hex head screws (#1) and two washers (#2) into the threaded holes.
7)
Remove Guide Pins and Fasten Two Hex Head Screws and Two Washers to Complete Assembly
a. Remove the two guide pins.
b. Hand-tighten two hex head screws (#1) and two washers (#2) into the two remaining threaded holes.
c. Finish tightening all nine hex head screws in a crisscross pattern to 100 in-lbs.
d. Store the guide pins (Item A), safety wooden boards (Item B), and screws (Item C) in a safe location for
future assembly/disassembly.
TE-10KS-MD & TE-10PS-MD
7
Advertisement
