Electrical Specification - Optoma EP758 Service Manual

1-3 Electrical specification

Input connections
- Terminal:-
DVI x 1 (Analog RBG, Component, HDTV, Digital RGB, HDCP)
15 pins D-sub VGA signal input
Composite Video X 1.
Three RCA connectors for Component video/HDTV input
Audio Input X 1
USB X 1 (for remote mouse)
S-Video X 1
IR x 2 (Front, Top panel)
RS232 Serial Control x 1 (3 pin mini din)
Power Cord x 1
- PC/Video: One DVI-I + USB(analog and digital YCbCr/YPbPr w/ HDCP).
- One D-Sub 15-pin connector for analog RGB/component video/HDTV
- Video: 3-RCA type connector for YPbPr component video.
One mini DIN for S-video connector.
One composite RCA type connector.
- Control: 1 RS-232 (use standard Mini Dim 3 pins configuration) (with talk back ability and 9600
baud rate, talk back ability must include lamp hours) (on/off and all inputs should have
discreet IR and RS-232 commands)
One Audio input for every input- (Phone Jack, Stereo)
Outputs
Audio
Lock
Tilt angle
Coretronic Corporation
One 15pin D-Sub Output
One audio out
Two watt built in two speakers respectively
One Kensington key lock hole
7 degrees with elevator mechanism
1-3
EP758/EP759