Celexon PS Ultraflat User Manual page 12

WARNINGS
The purpose of these operating instructions is to familiarise you with the operation of
this product. Therefore, keep these instructions in a safe place, so that you can refer to
them at any time.
• Do not begin installation until you have read and understood the complete opera-
ting instructions.
• Carry out the installation with another person to ensure safe installation.
• Remove the product from its packaging and remove all packaging materials. Make
sure that there is no packaging material on or in the product. If you notice any da-
mage to the packaging, also check whether there is any damage to the product.
If you notice any external damage to the unit or any unexpected or unusual fun-
ctioning, do not continue to use the product. Contact the dealer from whom you
purchased the product or celexon directly (Web: www.celexon.co.uk, Mail: info@
celexon.co.uk) for further information.
• To ensure trouble-free operation, the product may only be used indoors, it is NOT
suitable for outdoor use.
• The use of the item and accessories is forbidden to children under 16 years of age.
• Ensure that no children play with the product or are in the vicinity without super-
vision.
• Ensure that the product is not installed in places where people will be staying be-
neath for long periods of time.
• Modifying or altering the product will compromise product safety.
• Handle the product with care. It can be damaged by knocks, blows or falling from
even a small height.
• Keep the product away from moisture and do not use it in dusty environments.
• Use the product only in the manner intended. Any other use may cause damage to
the product or its surroundings.
• Tighten the screws but do not overtighten them. Overtightening (e.g. by using a
cordless screwdriver) may cause damage and affect the secure hold of the product.
• If necessary, obtain suitable mounting material for your mounting surface. Make sure
that the surface has sufficient load-bearing capacity to hold the product and other
components securely and permanently. After assembling the product and other
components, they must be checked for sufficient strength and operational safety.
• Suspended loads must be checked for strength and load-bearing capacity at least
twice a year.
1