Satco NUVO 67-136 Installation And Safety Instructions

LED REMOTE LAMP HEADS
Models: 67-136, 67-137
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.

WARNING: Risk of Fire or Electric Shock

• Disconnect power before installation or any maintenance
of the fixture.
• To avoid damage, falling, electric shock or fire, do not modify the
fixture or replace accessories.
• Only authorized, qualified personnel should install this fixture and
should follow the owner's manual.
• Do not dismantle the fixture.
• Do not touch the power supply when the fixture is operating.
• For use in environments where an accumulation of non-conductive
dust on the fixture may be expected.
• Suitable for wet location.
• Do not mount near gas or electric heaters.
• Do not let power cords touch hot surfaces.
• Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized personnel.
• The use of accessory equipment is not recommended and may
cause an unsafe condition.
• Do not use this equipment for other than intended use.
IMPORTANT: This product must be installed in accordance with the
applicable installation code by a person familiar with the construction
and operation of the product and the hazards involved.

INSTALLATION

1. Connect wires to DC 3~12V supply in accordance with local and
national code. Yellow wire is for positive (+), purple wire is for
negative (–).
2. Secure fixture to Junction Box with hardware provided.
3. Make proper electrical connection, refer to Wiring Diagram, then
push excess wire into Junction Box.
© Copyright 2023 Satco Products, Inc. 3/23 v1.2
1
67-136: Single Head
67-137: Double Head

WIRING DIAGRAM

Satco Products, Inc.
Brentwood, NY 11717