Table of Contents
Advertisement
Once the time has elapsed
The hotplate switches off. A warning signal sounds. The
time program function lights up
the display.
When the
0
symbol is pressed, the indications turn off
and the beeping stops.
Notes
To set a cooking time of under 10 minutes, always
■
touch 0 before you select the required value.
If a cooking time was programmed for several
■
hotplates, the time information for the selected
hotplate is shown in the timer display.
Select the relevant hotplate to call up the remaining
■
cooking time.
You can set a cooking time of up to
■
The kitchen timer
You can use the kitchen timer to set a time of up to 99
minutes.
This functions independently from the hotplates and
from other settings. This function does not automatically
switch off a hotplate.
Setting
Touch the
symbol repeatedly until the
0
1.
indicator lights up.
‹‹
Set the desired time in the settings area.
2.
After a few seconds, the time begins to elapse.
Changing or deleting the time
Touch the
symbol repeatedly until the
0
lights up.
Change the time in the settings area or set
to delete the programmed time.
When the time has elapsed
An audible signal sounds.
display and the
indicator lights up. The displays go
V
out after 10 seconds.
When the
0
symbol is touched, the displays go out
and the audible signal ceases.
for 10 seconds in
‹‹
minutes.
ŠŠ
V
lights up on the timer display.
indicator
V
in order
‹‹
appears on the timer
‹‹
vPowerBoost function
T he PowerBoost function enables you to heat up large
P o w e r B o o s t f u n c t i o n
quantities of water faster than when using heat setting
.
Š
This function can always be activated for a hotplate,
provided the other hotplate in the same group is not in
use (see illustration). Otherwise,
the display for the selected hotplate; the
will then be set automatically without activating the
function.
In the combi zone, the PowerBoost function can
Note:
only be activated if the two hotplates are used
independently of each other.
Activation
Select a hotplate.
1.
Touch the
symbol.
á
2.
lights up on the display.
›
The function is activated.
Deactivation
Select the hotplate.
1.
Touch the
symbol.
á
2.
The
display goes out and the hotplate switches
›
back to the
heat setting.
Š
The function is deactivated.
In certain circumstances, the PowerBoost
Note:
function can switch itself off automatically in order to
protect the electronic elements inside the hob.
PowerBoost function
and
will flash in
›
Š
heat setting
Š
en
15
Advertisement
Table of Contents
