Table of Contents
Advertisement
Steps
1. Loosen the four or seven captive screws that secure the heat sink to the system board.
NOTE:
Loosen the captive screws in the reverse sequential order mentioned on the heat sink [4 > 3 > 2 > 1] or [7 > 6 >
5 > 4 > 3 > 2 > 1].
NOTE:
The number of screws varies depending on the configuration ordered.
2. Remove the two screws (M2x4) that secure the heat sink to the system board.
3. Lift the heat sink from the system board.
Installing the fan and heat-sink assembly (Integrated GPU)
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
If either the system board or the heat sink is replaced, use the thermal grease provided in the kit to ensure that
thermal conductivity is achieved.
The following images indicate the location of the heat sink and provide a visual representation of the installation procedure.
For computers shipped with integrated graphics
For computers shipped with discrete graphics
82
Removing and installing Field Replaceable Units (FRUs)
Advertisement
Table of Contents
