Table of Contents
Advertisement
Figure 3. Inner frame removal
Steps
1. Disconnect the speaker cable from the system board.
2. Remove the speaker cables from the routing guides on the palm-rest assembly.
3. Remove the twelve screws (M2x3) that secure the assembly-inner frame to the palm-rest assembly.
4. Remove the assembly-inner frame off the palm-rest assembly.
Installing the assembly-inner frame
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the assembly-inner frame and provide a visual representation of the installation
procedure.
Steps
1. Align the screw holes on the assembly-inner frame with the screw holes on the system board and the palm-rest assembly.
2. Replace the twelve screws (M2x3) that secure the assembly-inner frame to the palm-rest assembly.
3. Connect the speaker cable to the system board.
4. Route the speaker cables through the routing guides on the palm-rest assembly.
Next steps
1. Install the
WLAN
card.
2. Install the
4G WWAN card
70
Removing and installing Field Replaceable Units (FRUs)
or
5G WWAN
card, as applicable.
Advertisement
Table of Contents
