Description Of The Main Components - Mitsubishi Electric MEGR Manual

3.5 Description of the main components

Air-cooled condensers for IT Cooling equipped with axial fans with horizontal or vertical air flow. Air flow from coil to fan.
The design solution allows a high degree of application flexibility. There are 4 series with 12 models each.
Between the internal unit and the condenser, it is necessary to make the cooling and electrical connection of the condensation control
proportional signal and of the alarms.
The machines in this series are designed and built for use in technological air conditioning systems.
The machines are not suitable for ducting the intake and discharge of air.
On request, it is possible to have:
•
The support feet kit, to transform the machine into a machine with vertical air flow;
•
The shut-off taps kit for the cooling line;
•
Protective E-coating treatment for the microchannel coil;
•
The Finguard protective treatment for the tube and fin coil;
•
The earthquake anchoring kit (only on machine with microchannel coil and single row of fans).
In order to ensure maximum performance and guarantee the safety of people, the product and the environment, before installation it
will be necessary to complete a full design of the system within which the machine will be installed, assessing all the predicted and
foreseeable critical points during its life, from installation to dismantling.
The machines essentially consist of a heat exchange section and one or more fans.
They work by condensing the coolant in the cooling circuit.
The air from the external environment is made to flow through the coil by the fans to allow the condensation of the cooling fluid.
The heat extracted from the coil is released into the ambient air.
The remote condenser is connected to the main machine by cooling pipes.
For further machine characteristics and technical data, please refer to the Data Book.
Front view
Installation, use and maintenance manual
Rear view
14