Configuration In Max - National Instruments PCMCIA-4050 Getting Started Manual

Configuration in MAX

Note If the device does not pass the test, power off the PC, remove the DMM, and repeat
the appropriate installation procedure. If the device still does not pass the test, visit our
support Web site at
Note The Run Test Panels option is currently not available for the NI 4070.
© National Instruments Corporation
1. Launch Measurement & Automation Explorer (MAX) to configure
and test the DMM. MAX detects the DMM you installed.
2. Double-click Devices and Interfaces to see the DMM listed. If the
device is not listed, press <F5>.
3. Right-click the DMM icon, and select Properties. Refer to the device
number and resources assigned to the DMM by MAX.
4. In the Configuring Device window, click Test Resources. A dialog
box appears and indicates if the DMM has passed the resource test.
ni.com/support
5. Click Run Test Panels to run the functional test panels and to use the
DMM. Refer to the
the DMM.
6. Click Close to close the Test Panel.
7. Click OK to close the Properties window and return to the MAX main
window.
8. Exit MAX.
.
Connecting Signals
13 NI Digital Multimeters Getting Started Guide
section to connect a signal to