Table of Contents
Advertisement
PLACEMENT WITHIN THE SHOP /
ESTABLISHING A SAFETY ZONE
PLACEMENT WITHIN THE SHOP
This machine should be installed and operated only on a
solid, flat and stable floor that is able to support the
weight of the sander (453 lbs - 206 kgs) and the operator.
Using the dimensions shown as a guideline, plan for pla-
cement within your shop that will allow the operator to
work unencumbered and unobstructed by foot traffic
(either passing shop visitors or other shop workers) or
other tools or machinery.
ESTABLISHING A SAFETY ZONE
For shops with frequent visitors or multiple operators, it is
advisable to establish a safety zone around shop
machinery. A clearly defined "no-go" zone on the floor
around each machine can help avoid accidents that
could cause injury to either the operator or the shop visitor. It is advisable to take a few moments to either paint
(using non-slip paint) or using tape, define on the floor the limits or perimeter of each machines safety zone. Take
steps to ensure that all operators and shop visitors are aware that these areas are off limits whenever a machine is
running for everyone but the individual operating the unit.
LIFTING AND HANDLING THE MACHINE
THIS MODEL 15-010S SANDER IS VERY HEAVY.
TO LIMIT THE RISK OF SERIOUS INJURY OR DAMAGE TO THE MACHINE, READ AND FOLLOW ALL RECOMMENDATIONS BELOW.
A forklift with steel cable or a hydraulic hand pallet truck
will be required to lift the sander.
Note: Before lifting the sander, unscrew the hex head wood
screws securing the machine to it's shipping crate
the supplied 14 mm open end wrench or a 14 mm socket
wrench.
The four 1/2" Hex. bolts and nuts
to the floor, for optional permanent installation.
SAFETY RULES FOR MACHINE LIFTING
1. Any equipment used to lift this machine should have
a rated capacity in excess of 453 lbs (206 kgs).
2. If using a steel cable, make sure it is strong enough
so it won't break during the lifting.
3. The forklift must only be driven by a licensed driver.
4. The forks of forklift must protrude beyond the underside of the machine.
5. Pay special attention to the balance of the machine while lifting. (The motor side is much heavier)
6. Have another person help guide the way when lifting the machine.
7. Lower the machine slowly and carefully. Do not let the machine drop or jolt onto the floor.
, using
are for bolting the sander
9
Advertisement
Table of Contents
