Table of Contents
Advertisement
OVERLOAD PROTECTION/CIRCUIT BREAKER
The magnetic safety switch on this sander is equipped with an overload protection feature. To prevent an electrical
overload from damaging the motor, in the event of a spike in line voltage or amperage draw, the internal overload
protector will automatically be tripped, thereby cutting off power to the motor.
To reset the overload protection switch after it has been tripped proceed as follows:
TO AVOID UNEXPECTED OR UNINTENTIONAL START-UP BE CERTAIN THAT THE POWER SWITCH HAS BEEN SET TO THE OFF POSITION
BEFORE RE-SETTING THE CIRCUIT BREAKER.
SWITCH OFF
1. Set the power switch on the sander to the off posi-
tion and disconnect the machine from the
power source .
Note: If the sander is permanently connected to a cir-
cuit (hard-wired), set the wall panel circuit breaker or
main circuit interrupter to the off position.
FRONT TABLE HEIGHT ADJUSTMENT
Adjusting the height of the table allows an even wearing
of the sanding belt surface by allowing you to use diffe-
rent sections of the belt depending on the height of the
workpiece. To raise or lower the table:
1. Loosen the two lock knobs
adustment knob
height.
2. Tighten the two lock knobs to secure the table in posi-
tion.
Tip: To maximize belt usage when working with shorter
work pieces, periodically adjust the table height to sys-
tematically make use of various portions of the belt. For
example: a series of 2" tall workpieces can be separated
into 3 smaller batches with each batch being sanded
with the table set at different heights to use in sequence
the lower, middle or upper portion of the belt.
FRONT TABLE INCLINATION ADJUSTMENT
The front table can be inclined left or right for sanding
irregular workpieces.
1. Loosen the two lock knobs
end of the table by hand either left or right
2. Re-tighten the lock knobs to lock the table in position.
12
then turn the height
until the table is at the desired
and raise or lower one
2. Unscrew the 2 screws
box front cover then press the red reset button
3. Reinstall the control box cover.
4. Reconnect the sander to the power source.
5. You can now restart the sander by pushing on the
green button ON.
.
and remove the control
.
Advertisement
Table of Contents
