Beko WMB 51431 Manual page 15

Unplug the machine to cut off the supply
power.
Temperature of the water inside the
A
machine may rise up to 90 ºC. To avoid
burning risk, filter must be cleaned after
the water in the machine cools down.
Open the filter cap.
If the filter cap is composed of two pieces,
press the tab on the filter cap downwards
and pull the piece out towards yourself.
If the filter cap is one piece, pull the cap from
both sides at the top to open.
You can remove the filter cover by slightly
C
pushing downwards with a thin plastic
tipped tool, through the gap above the
filter cover. Do not use metal tipped tools
to remove the cover.
Some of our products have emergency
draining hose and some does not have. Follow
the steps below to discharge the water.
Discharging the water when the product has
an emergency draining hose:
Pull the emergency draining hose out from
its seat Place a large container at the end of
the hose. Drain the water into the container
by pulling out the plug at the end of the hose.
When the container is full, block the inlet of the
hose by replacing the plug. After the container
is emptied, repeat the above procedure to
drain the water in the machine completely.
When draining of water is finished, close the
end by the plug again and fix the hose in its
place. Turn the pump filter to take it out.
Discharging the water when the product does
not have an emergency draining hose:
Place a large container in front of the filter to
catch water from the filter. Loosen pump filter
(anticlockwise) until water starts to flow. Fill
the flowing water into the container you have
placed in front of the filter. Always keep a piece
of cloth handy to absorb any spilled water.
When the water inside the machine is finished,
take out the filter completely by turning it.
Clean any residues inside the filter as well as
fibers, if any, around the pump impeller region.
Install the filter.
If your product has a water jet feature, be
A
sure to fit the filter into its housing in the
pump. Never force the filter while installing
it into its housing. Seat the filter into its
place completely. Otherwise, water may
leak from the filter cap.
If the filter cap is composed of two pieces,
close the filter cap by pressing on the tab. If it
is one piece, seat the tabs in the lower part into
their places first, and then press the upper part
to close.
15
EN