Table of Contents
Advertisement
A2TAPE OPEN/CLOSE
4—0-9,+10
cD
In the programmed edit recording function, the tracks can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
;
The programmed edit recording will not start from apoint halfway
through the tape. The tape must be recorded on from the
beginning of either side.
Use the remote conirol from steps 3 to 8.
1 Load the tape into the cassette tray.
Load the tape with the side to be recorded on first facing
upward.
2 Press CD.and load the disc(s).
. 3 Press CD EDIT/CHECK twice.
"PRGM EDIT" and "PRGM'" light up on the display.
"PRGM
PRGM EDIT
When "Al' is selected, press CD EDIT/CHECK again.
4 Press the numbered buttons 0-9 to designate the
tape length.
10 to 99 minutes can be specified.
Maximum recording
° <<, >
and MULTI JOG are also available to designate
the tape length.
22 ENGLISH
5 Press DISC DIRECT PLAY, then press one of the
numbered butions 1-3 within 3 seconds to select
a disc. Then, press the numbered buttons 0-9 and
+10 to programme a track.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY and 2, then +10 and 0.
Selected disc
Programme
.
;
number
number
Remaining time on side A
Programmed track numbers
Selected track number
6 Repeat siep 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
7 Press CD EDIT/CHECK
to select side B and
program the tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B(reverse side)
SE
8 Press @/OREC/REC MUTE, and then press
> /<> within 2 seconds to start recording.
The tape is rewound to the beginning of the side facing
upward, the lead segment is played through for 10 seconds,
and recording starts. When recording on the side A facing
upward ends, recording on the other side B starts.
To stop recording
Press ll. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK to select side A or B,
and press <4 or >
repeatedly.
.
Programmed track numbers
Track number
—
ra
SS.
>
Disc number
Programme number
To change the programme of each side
Press CD
EDIT/CHECK
to select side A or B, and press
MICLEAR
io clear the program on the selected side. Then
program tracks again.
To clear the edit programme
Press MICLEAR twice so that "EDIT" disappears from the display.
Advertisement
Table of Contents
