LG XD3A25UPS Owner's Manual page 25

Table of Contents

Advertisement

3
Close the lid to lock the dispenser. Rinse aid is
dispensed automatically during the final rinse
cycle.
CAUTION
• Wipe off any spilled rinse aid to prevent suds.
NOTE
• Only use liquid rinse aid in the appliance.
• Do not overfill the rinse aid dispenser.
• Too much or too little rinse aid can inhibit the
drying results.
• If rinse aid flows out of the dispenser, wipe it off.
Otherwise many suds can occur and stain the
dishwasher.
Setting the Rinse Aid Level
The dispenser has five adjustment levels. The
default programme is rinse aid level 2. This can be
checked and altered by using the buttons on the
control panel.
1
Ensure the appliance is off.
2
Press Power and Dual Zone simultaneously to
check the current setting.
3
Press Delay Start to change the rinse aid
dispenser setting. Each press of the button
changes the setting one step from L0(off) to L4.
4
Once the desired rinse aid dispenser setting is
selected, press START to save.
• The power turns off after saving.
CAUTION
• If the rinse aid lid is not closed properly, a large
amount of rinse aid will release into the tub and
cause washability problems.
NOTE
• The Rinse Aid Refill
more rinse aid is needed.
• If you notice cloudy spots, streaks or water
marks on the glassware after washing, increase
the setting level.
• Setting the control too high can cause foaming,
which will cause poor wash results.
• If the glass is smeared or foam is present on the
bottom, decrease the level setting.
• Setting the rinse aid control too low can cause
spotting and streaking on dishes and poor
drying results.
OPERATION
e
icon will illuminate when
25

Advertisement

Table of Contents
loading

Table of Contents