Steps
1. Place the display panel and display assembly on a clean and flat surface.
2. Connect the display cable to the connector on the display panel and close the latch.
3. Adhere the tape to secure the display-cable connector latch to the display panel.
4. Lift and rotate the display panel, and then place the display panel on the display assembly.
5. Place the display bezel on the display assembly.
6. Align the tabs on the display bezel to the slots on the display assembly.
7. Press down on the display bezel and snap the display bezel in place.
Next steps
1. Install the hinges.
2. Install the
display
bezel.
3. Install the
hinge
caps.
4. Install the
display
assembly.
5. Install the
wireless
card.
6. Install the
base
cover.
7. Install the
SD
card.
8. Follow the procedure in
112
Removing and installing Field Replaceable Units (FRUs)
After working inside your
computer.