Toshiba MV19L2W Service Manual page 10

2-6: LINK UNIT (Refer to Fig. 2-6)
1. Set the Link Unit to the Eject position.
2. Remove the (A) side of the Link Unit first, then remove
the (B) side.
Link Unit
(A)
Main Chassis
2-7: LOADING MOTOR ASS'Y (Refer to Fig. 2-7)
1. Remove the Link Lever.
Remove the screw 1.
2.
3. Remove the Loading Motor Ass'y.
Unlock the 2 supports 2 and remove the Deck PCB
4.
(BOT).
Main Chassis
• Screw Torque: 5 ± 0.5kgf•cm
2-8: SENSOR COVER L3 (Refer to Fig. 2-8)
Unlock the support 1 and remove the Sensor Cover L3.
1.
Main Chassis
DISASSEMBLY INSTRUCTIONS
(B)
Link Unit
Main Chassis
Fig. 2-6
Loading Motor Ass'y
2
1
Deck PCB
(BOT)
Link Lever
Fig. 2-7
Sensor Cover L3
1
Fig. 2-8
2-9: TENSION ASS'Y (Refer to Fig. 2-9-A)
1. Move the Inclined S Ass'y to the back side.
2. Remove the Tension Spring.
Unlock the support 1 and remove the Tension Arm
3.
Ass'y.
4. Remove the Tension Adjust.
Unlock the 2 supports 2 and remove the Tension Band
5.
Ass'y.
Unlock the support 3 and remove the Tension Holder.
6.
7. Remove the SS Brake Spring.
8. Remove the SS Arm Brake.
2
2
Tension Spring
1
3
SS Brake Spring
SS Arm Brake
NOTE
When you install the Tension Adjust, install as shown in
Fig. 2-9-B. (Refer to Fig. 2-9-B)
Adjust the direction of the Marker to inside.
2-10: T BRAKE ASS'Y (Refer to Fig. 2-10)
1. Remove the T Brake Spring.
2. Remove the T Brake Ass'y.
T Brake Ass'y
Tension Adjust
Tension Band Ass'y
Tension Arm Ass'y
Tension Holder
Inclined S Ass'y
Fig. 2-9-A
Fig. 2-9-B
T Brake Spring
Fig. 2-10