Advertisement
@ Bottom cabinet
Ne.
Parts code
Description
| Price rank
1 | GCABA7081RCZZ
Bottom cabinet
3)Procedure
Description
igR-i921
IER-2396)
, | Remove
three top cabinet holding
screws.
2 | Remove
the granding wire from the|
top of the drawer.
3 | Remove the ring core from the
cabinet.
Remove
the top cabinet from the
bottom cabinet.
4}
Remove
the top cabinet from the
drawer.
Unfasten
the
transformer
and drawer connectors.
Remove two bottom cabinet holding
screws.
Remove the transiormer holding screw.
JO)
O
Remove the transformer cover from
the drawer.
fol
a
Get the bottom cabinet ready. Use
the bottom cabinet that equipped
to
the ER-192t and ER-23:
Bottom cabinet
Insert the wire of the drawer solenoid
microswitch in the clamp and install the
'clamp to the shietd plate. Note that there
i8.a microswitch wire provided for use
with the UK version model.
9| Note: Even for the 'drawer with no
microswitch
it is 'necessary to
install a olamp-to the shield plate
without fail.
This means that two clamps must
be instailed without exception.
GCABA7081RCZZ
LBSHC6638RCZZ
Route
the
solenoid
microswitch
connector through the square hole
beneath the bottom cabinet.
Place the shield plate under the
back
of the bottom
cabinet,
and
11} fasten
the
rubber
footings
with
scraw at four locations and at 4
center,
DUNTK9207RCZ2 | OTN SER]
GLEGGG6634RCZZ
XWHSD30-05080
XUBSD30P
14000
XUBSD30P08000
Install the transformer cover to the
fear right of the bottom cabinet and
fasten the transformer with screws.
(Use new screw for the ER-+9! 1.)
XBPSDSOP35KSO
Replace
the
top
cabinet
to the
bottom cabinet. Fasten the transformer
and drawer connectors as this point.
14] Fasten the granding wire,
Fasten the ring core.
(Use new screw and nut.)
Nut
XBPSD30P20KSO
XNESD30-24000
Fasten the top cabinet with three
screws.
Use & new
screw
for the
printer
of the ER- 191 1 and for the
'One in the rear left.
Screw, printer
| Screw, rear left
XFPSD3O0P20000
XWHSD30-05080
LX-BZ6756RCZZ
Tailor the drawer solenoid microswitch wire to the size the user
wants. Use the AWG22 wire for this.
4) Setting
Master reset
While pressing the journal feed key, rotate the MODE switch from
SRV2 to SRV1 position.
J / gg
Advertisement
