Beko B3D512844UW User Manual page 52

Foam is overflowing from the detergent
drawer.
• Too much detergent is used. >>> Mix 1
tablespoonful softener and ½ l water and
pour into the main wash compartment of
the detergent drawer. >>> Put detergent
into the product suitable for the pro-
grammes and maximum loads indicated
in the "Programme and consumption
table". When you use additional chemic-
als (stain removers, bleaches and etc.),
reduce the amount of detergent.
Laundry remains wet at the end of the
programme. (*)
• Excessive foam has occurred and auto-
matic foam absorption system has been
activated due to too much detergent us-
age. >>> Use recommended amount of
detergent.
Drying lasts too long.
• The machine might have been over-
loaded. >>> Do not overload the machine.
• Spinning might not be sufficient for laun-
dry. >>> Select a higher spin speed in the
washing step of the Washer-Dryer.
• Tap is turned off. >>> Turn on the taps.
Laundry comes off wet after the drying
step.
• The programme selected might not be
suitable for the type of laundry. >>>
Check the care labels on clothes and se-
lect a programme accordingly, or select
timed programmes additionally.
• The machine might have been over-
loaded. >>> Do not overload the machine.
• Spinning might not be sufficient for laun-
dry. >>> Select a higher spin speed in the
washing step of the Washer-Dryer.
Machine does not start or programme
cannot be started.
• Power cable might be unplugged. >>>
Make sure that the power cable is
plugged in.
• Programme might not be set, or the
Start/Pause/Cancel button might be not
pressed. >>> Make sure the programme
is set and the machine is not in Standby
mode.
• Child lock might be activated. >>> Dis-
able Child Lock.
Laundry shrinks, fades, tarnishes or
gets damaged.
• The programme selected might not be
suitable for the type of laundry. >>>
Check the care labels on clothes and se-
lect a programme accordingly, or select
timed programmes additionally. You
should not dry laundry that is not suitable
for drying.
Machine does not dry.
• Laundry might not be dried or the drying
step might not be enabled. >>> Check if
the drying function is selected after the
selected washing programme.
Loading door cannot be opened.
• The door of your machine might not be
opening due to safety reasons. >>> If the
door locked indicator is still active on the
display after the drying step, the machine
will keep the door locked for your safety
until it cools down.
• If there is no power, loading door of the
product will not open. >>> To open the
loading door, open the pump filter cap
and pull down the emergency handle po-
sitioned at the rear side of the said cap.
See Loading Door Lock [} 40]
(*) The product does not switch to spinning
step when the laundry is not evenly distrib-
uted in the drum to prevent any damage to
the product and to its surrounding environ-
ment. Laundry should be rearranged and re-
spun.
(**) Regular drum cleaning is not applied.
Clean the drum regularly. See --- MISSING
LINK ---
If you cannot eliminate the problem
although you follow the instructions
in this section, consult your dealer
or the Authorised Service Agent.
Never try to repair a nonfunctional
product yourself.
EN / 52