Sony ICF-SW7600 Operating Instructions Manual page 16

ow to Use the Supplied SW Com
pact Antenna— For better SW reception
sually the telescopic antenna is sufficient for SW reception. However, in a
etat or concrete building, the use of the supplied SW compact antenna is
commended.
Coupler
Connect an optional coaxial cable to the supplied antenna connector.
Connect the antenna connector to the EXT ANT jack of the ICF-SW7600.
2 pQ2 E
Center
conductor
T ARER 5
1a Steel-frame building, a mountainous area, at a distance from the
ansmitter or in a location where ignition noise is severe, FM reception may
e unsatisfactory with the telescopic antenna. In this case, connect a
ommerciaily available external FM antenna with a 75-ohm coaxial cable.
75-ohm coaxial cable
1 Fully pull out the cord from the case.
2 Attach the coupler to the telescopic antenna.
3 When the window can be opened:
Extend the cord and the case out through the window, after making sure
there is no danger.
When the window cannot be opened:
Fully extend the cord along the frame of the window.
After using
Method A
With a connecting cord, connect the OUTPUT jack of the antenna controller
(supplied with the AN-1 or the AN-102) and the EXT ANT jack of the
ICF-SW7600.
Method B (for LW/MW reception onty)
1 With a connecting cord, connect the OUTPUT jack of the antenna
controller and the INPUT jack of the antenna coupler (supplied with the
AN-1 or AN-102).
2 Put the antenna coupler near the ICF-SW7600.
Example: When the AN-1 is used.
(CF-SW7600
AN
Notes
e When receiving MW or LW broadcasts without an external antenna, be sure
to disconnect a SW external antenna. Otherwise, you cannot receive them
as the built-in ferrite bar antenna does not function.
© If there is lightening, do not touch the wire of an external antenna and
disconnect its AC power adaptor (if connected) immediately.
+ When using an external antenna, retract the telescopic antenna.
* Locate an outdoor antenna as far away from the street as possible.
e For details about an externat antenna, refer to its instruction manual.