Sony ICF-SW7600 Operating Instructions Manual page 10

—To have a station scanned automatically
the frequency of a desired station.
1 Set POWER/LOCK to POWER.
2 Press ON/OFF.
The radio is turned on.
3 Press MANUAL TUNING (+ or —) repeatedly while
1 Set POWER/LOCK to POWER.
2 Press ON/OFF.
3 Receive a broadcast band by pressing MANUAL
TUNING while keeping BAND pressed, or by pressing
Sr baw in bee pice prey
"$ keeping BAND pressed to search for the i
a č PRESET/DIRECT TUNING. (Refer to the table on the
a
approximate frequency of a desired station.
a
3 $
:
The lowest frequency of each band or the meter band
: a eta
eles Ta for the frequency range of each broadcast
K
of SW appears in the display.
as $
:
a
if you keep MANUAL TUNING pressed, the band
ne
:À 4 Press SCAN TUNING START/STOP.
changes continuously.
ch
x
Within the frequency range of the table on page @,
_
a
E]
scan tuning will begin and stop automatically for 1.5
4 Press MANUAL TUNING (+ or
—) repeatedly to vË
:$
seconds when a station is received and then the
Eà
search for a desired station. ay r tuning indicator lights up. i
3 5 Press SCAN TUNING START/STOP again to listen to +4
f :
3
B i i
pi
k ee
a
aa
mate k
3
the station being received.
4
: 6 Tune in the station more precisely by MANUAL $
To prevent accidental change of the receiving station
aS
TUNNA
¢ + or sit pecans: ny by
oe
Press KEY PROTECT. The O=» mark appears in the display window and all
a
4
et
the buttons on the front panel will not work.
aw
To release the KEY PROTECT function, press KEY PROTECT again.
at
a
ip s
When the station is tuned in
an}
The TUNE indicator lights up. Ai BRE) BUHL x
Frequency band changes continuously
If you keep MANUAL TUNING (+) pressed, the frequency band being tuned
in will change from LW to MW, SW, FM and then back to LW.
What is meter band?
SW is devided into 13 bands by the wave length (meter).
Each band is called meter band (see page @).