5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com VENTING YOUR OVEN: 1. The purpose of ventilating hoods is to direct and capture smoke, grease-laden vapors, heat, odors, or fumes. 2. Low temperature equipment (maximum temperature 250°F/121°C) does not produce heat, odors, fumes,...
5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com OPERATING INSTRUCTIONS HOW TO START UNIT: (for first-time operation only) A new oven needs to “burn off” factory oils and glue before it’s first use. Do NOT load food into oven until this has been done! 1.
5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com OPERATING INSTRUCTIONS, continued: HOW TO SET THE CONTROL, continued FOR PROBE COOK OPERATION: Press the SELECT button to choose the probe mode. PROBE TEMPERATURE: 1.
Page 6
5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com OPERATING INSTRUCTIONS, continued HOW TO OPERATE WITH FOOD, continued HOW TO SET HOLD-ONLY MODE: 1. Push power switch to “ON”. 2. Press the STOP button and oven will switch to HOLD cycle.
5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com MAINTENANCE: WATER PAN Drain, wipe and fill water pan daily. (Clear vinyl drain-hose is provided). 1. Push hose onto drain nozzle under the base.
Page 8
5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com MAINTENANCE INSTRUCTIONS TROUBLE-SHOOTING GUIDE If unit gets too hot or won’t shut off, disconnect power at branch panel. DO NOT UNPLUG CORD! If hot unit is NOT working, first check the following causes: 1.
5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com MAINTENANCE INSTRUCTIONS TROUBLE-SHOOTING GUIDE, continued HOW TO ADJUST THE DOOR LATCH: 1. For vertical (up and down movement) adjustment: a. Loosen (2) screws located in magnetic strike.
5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com Include all information on nameplate when ordering parts. ITEM DESCRIPTION 1. Switch (On/Off) 2. Microprocessor Control 3. Vent Fan 4. Fan Guard 5. Fuse Fuse Holder 6.
Page 11
5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com For “PASS-THRU” OVENS CO or RO151FPWUA SERIES: Include all information on nameplate when ordering parts. FIGURE 3; Hot Unit w/o top cover (For parts description, refer to page 10) FIGURE 4;...
Page 12
Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 12 of 13 Rev. 8 (1/05) Page 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com REPLACEMENT PARTS For OVENS CO or RO151FPWUA SERIES: Include all information on nameplate when ordering parts.
Need help?
Do you have a question about the CO151FPWUA12B and is the answer not in the manual?
Questions and answers