Loading A Cassette Tape - Teac W-850R Owner's Manual

OPERATIONS
Loading a Cassette Tape
1 Use your finger or a pencil to turn ():
the cassette's hub and take up oA a
any slack tape. A
Note: Avoid touching the tape.
Fingerprints attract dust
and dirt.
2 Press the eject button (,.%,)* to
open the cassette compartment
door.
3 Load the cassette tape with its
open edge facing down.
4 Gently close the compartment
* Notes:
© The cassette holder cannot be
opened during recording or
door. playback.
Tape Travel Depending on Setting of REV MODE Switch
Setting | Tape Travel
Beginning Side B End Stop Start
—_— LoS ee a
~_—
Start Stop End Side A Beginning
When the tape reaches the end, playback or recording is released.
Side B A .
Beginning ® End (0) During forward play or recording, when the end of tape
SSeS eee > is reached, the direction of tape running is reversed to
Store Stop play or record in the opposite direction. Reverse play
= A Dstart or recording will continue to the end of the other side,
at which point play or recording is released.
End Beginning @® During reverse play or recording, when the tape
Side A reaches the end, play or recording is released.
PLAY mode (Tapes loaded in TAPE | or Il)
Side B ; 7
Beginning End During either forward or reverse play, when the end of
tape is reached, the direction of tape running is reversed
and play continues in the opposite direction. In this way,
the two sides of the tape are played back continuously;
the tape will stop after 5 cycles.
End Beginning
Side A
ca)
RECORD mode (TAPE II or TAPE |) |
a Side B
Beginning End
a =| Sto)
Start
"
© Operation is same as =>.
Start
End Beginning
Side A
*CONT PLAY (Continuous Playback) and CONT RECORDING (Continuous Recording) — Refer to
"Continuous Playback" and "Continuous Recording (TAPE | to TAPE Il)" on pages 8 and 12.