Parallel Recording - Teac W-850R Owner's Manual

Record Muting Operation (TAPE | and
TAPE Il)
REC MUTE
e Automatic spacing operation for 4-second
blanks (during recording)
Press the REC MUTE button during recording. The
tape movement continues and a blank space of
about 4 seconds is recorded (the RECORD
indicator blinks). The deck then enters the record-
pause mode automatically (both the RECORD and
PAUSE indicators light).
To restart recording, press the PAUSE button (the
PAUSE indicator goes off).
e Automatic spacing operation for 4-second
blanks (during record-pause)
In the record-pause mode, pressing the REC
MUTE button will initiate the above record-muting
operation automatically. The deck then returns to
the record-pause mode.
e For a blank of more than 4 seconds
During recording, hold the REC MUTE button
depressed for longer than 4 seconds. A blank
space will be left as long as the button is pressed.
Release the button to enter the record-pause
mode. To restart recording, press the PAUSE
button.
e For a blank of less than 4 seconds
After pressing the REC MUTE button during
recording, press the PAUSE button before 4
seconds has elapsed. The deck will stop and enter
the record-pause mode at the point at which the
PAUSE button is pressed. To restart recording,
press the PAUSE button again.
Note:
© During record muting operation (while the RECORD
indicator is blinking), pressing the REC MUTE
button again will release the record muting
operation and recording will restart without
stopping the tape.
ae ye
Parallel Recording
A single program source can be recorded onto the
two cassettes simultaneously.
1. Perform steps 1 to 7 described in "Recording with
TAPE | and TAPE II" except that in step 3, load
cassettes into both TAPE | and TAPE Il. (See
page 11.)
2. Press the PARALLEL REC button.
Notes:
© Recording will start in the direction indicated by
the direction indicator; therefore, set the direction
beforehand.
@ During recording, only STOP button of TAPE |
operates and the STOP, REC MUTE and PAUSE
buttons of TAPE II work.
@ If the STOP button is pressed, both TAPE | and
TAPE II will stop to end recording.
Continuous Recording (TAPE | to TAPE I!)
1. Load two recordable cassettes on both TAPES |
and Il.
2. Set the NR SYSTEM, etc. as required.
3. Set the REV MODE switch to the C=) position.
REV MODE
—— a — Set)
= Wt
CONT PLAY
4. Press the RECORD button, then PAUSE (or play)
button of TAPE | to start recording.
5. After recording with TAPE | is completed, TAPE II
starts recording automatically in the forward
direction.
6. To clear the continuous recording mode, press
the STOP button.
Notes:
@ In continuous recording, since recording with
TAPE II always begins in the forward direction,
make sure the cassette loaded in TAPE II can be
recorded on both sides.
@ If the tape running direction is set to reverse side
of TAPE |, recording will be done on only the
reverse side of the tape loaded in TAPE I.
© Continuous recording from TAPE II to TAPE | is
impossible.