Installing Memory Module - Biostar BIELK-IHT User Manual

2.1 Installing Memory Module

DIMM1/ DIMM2: DDR4 Memory Module Slot (260pins SO-DIMM)
Note
» » If the DIMM does not go in smoothly, do not force it. Pull it all the way out and try again.
Insert memory module into SO-DIMM socket at backside of motherboard.
1. Hold the SO-DIMM with its notch aligned with the memory socket of the board and insert it at a
30-degree angle into the socket.
2. Press down on the SO-DIMM so that the tabs of the socket lock on both sides of the module.
» » To avoid generating static electricity and damaging the SO-DIMM, ground yourself by touching a grounded metal
surface or use a ground strap before you touch the SO-DIMM.
1. Align a DIMM on the slot such that the notch on the DIMM matches the break on the Slot.
2. Insert the DIMM firmly into the slot until the retaining chip snap back in place and the DIMM is properly
seated.
Memory Capacity
DIMM Socket Location
DIMM1
DIMM2
DDR4 Module
512MB/1GB/2GB/4GB/8GB/16GB/32GB
512MB/1GB/2GB/4GB/8GB/16GB/32GB
BIELK-IHT User's Manual
Total Memory Size
Max is 32GB
Chapter 1: Introduction | 9