Table of Contents
Advertisement
■ State of indicator lamps
: The instruction is relating to the wireless LAN control
(optional).
Lighting pattern:
Off,
State
Automatic defrosting operation
⇒ Wait until finishing the defrosting
(maximum of 15 minutes).
Filter indicator
⇒ Clean the air filter and reset the filter
sign.
(3 times)
Error code display
⇒ Consult authorized service personnel.
(Fast)
Timer setting error because of Auto restart
⇒ Reset the clock and timer settings.
Test run operation (for authorized
personnel only)
⇒ Press
The power to the access point is not
on.
⇒ Check that the power to the access
point is on.
(Slow)
There is a possibility that the WLAN
adapter is not properly connected to
the access point.
⇒ Disconnect the power supply to the air
conditioner (via breaker or plug), and
then re-connect.
The software of the WLAN adapter is
being updated.
During the air conditioner registration
(pairing of WLAN adapter)
Restricted function
(In the multi-split connection) Standby
mode
⇒ Check the set operation mode of the
(Slow)
indoor units.
■ Manual Auto operation and Filter indicator
reset
You can operate the air conditioner with
Status
Time to keep pressing
In operation More than 3 seconds
Stopping
2 seconds or less
More than 3 seconds and
less than 10 seconds
More than 10 seconds
(Only for servicing.
*1) In multi-split connection, the operation mode follows the other indoor
units.
*2) To stop the forced cooling, press this button or
controller.
En-15
On,
Blinking,
Any state
Causes and solutions
to quit the test run.
on the indoor unit.
Mode or operation
Stop
Filter indicator reset
Auto
*1)
Forced cooling
)
*2)
on the remote
See
page
11
10
-
11
3
-
11
-
11
11
13
Advertisement
Table of Contents
