Table of Contents
Advertisement
To Change the RF output Channel
In some rare cases after tuning the TV to your VCR,
interference may be visible on the picture. To get rid of this
interference, you can manually adjust the RF output channel
Set VCR--TV switch to VCR for
a few channels up and down from the current setting. The
using the numeric buttons or
procedure is described below.
the v and A buttons.
Operations
1 Hold down MENU for 5 seconds or more.
® The VCR display changes as shown below and the
VCR picture on the TV displays this pattern.
Example for
Example for
NV-HD675A
NV-HD675EA
Q
ma)
g
3
g)
i
TriNOEX
eae
CD
ES
2 Enter the desired channel number (AU28-69, NZ21-69) by
using the numeric buttons or the VV and A buttons.
e Ensure that VCR--TV switch is set to VCR.
® Set the RF output channel of the VCR to "——" (RF
OFF) when the VCR is connected to the TV via the
AUDIO VIDEO cable.
Press the VW and A buttons to display "~—".
For NV-HD675A
For NV-HD675EA
ee)
ee
el
(RF OFF)
(RF OFF)
Example:
2: O©-+@+©
Oy
Vv
3 Press MENU to finish the setting mode.
ED
4 Retune your TV to the new RF channel for the VCR.
Note:
Even if the RF output channel has been changed, it is not
necessary to perform Auto Tuning.
Advertisement
Table of Contents
