BMW 2 GRAN COUPE 2021 Series Owner's Manual page 132

CONTROLS
The LED goes out.
The indicator light goes out.
Automatic Hold is switched off.
If the vehicle is being held by Automatic Hold,
press additionally on the brake pedal, when
switching off.
Malfunction
If the parking brake fails or in case of a fault, se‐
cure the vehicle against rolling before exiting.
A Check Control message is displayed.
Secure the vehicle against rolling away, for in‐
stance with a wheel chock, after exiting the vehi‐
cle.
After a power interruption
To reestablish parking brake functionality after a
power interruption:
1. Turn on standby state.
2. Pull the switch while stepping on the
brake pedal or selector lever position P is set
and then push.
This process may take a few seconds. Some
mechanical sounds associated with this process
are normal.
The indicator light is no longer illumi‐
nated as soon as the parking brake is
ready for operation again.
Turn signal
Turn signal in exterior mirror
When driving and during operation of the turn
signals or hazard warning system, do not fold in
the exterior mirrors, so that the signal lights on
the exterior mirror are easy to see.
132
Driving
Online Edition for Part no. 01405A37F24 - VI/21
Blinking
Press the lever past the resistance point.
Triple turn signal activation
Lightly tap the lever up or down.
The triple turn signal duration can be adjusted.
1. "CAR"
2. "Settings"
3. "Exterior lighting"
4. "One-touch turn signal"
5. Select the desired setting.
Brief blinking
Press the lever to the resistance point and hold it
there for as long as you want the turn signal to
flash.
High beams,
headlight flasher
Press the lever forward or pull it backward.
▷ High beams on, arrow 1.