Download Print this page

Whale AK1005 Installation & User's Instructions page 3

Grey waste tank with integrated intelligent control - service kits
Hide thumbs Also See for AK1005:

Advertisement

9.
TROUBLESHOOTING
Problem
Sensor fails to operate pump
Sensor is operating pump continuously
10.
WINTERIZING
The system must be fully drained, including the contents of the grey waste tank. If water is allowed to freeze in the system, serious damage to the plumbing, pump
and/or accessories may occur. Failures of this type will invalidate the warranty.
12.
EU DECLARATION OF CONFORMITY
We hereby declare, under our sole responsibility, that the enclosed equipment complies with the provisions of the following EC Directives.
Electromagnetic Compatibility Directive 2004/108/EC on the approximation of the laws of the Member States relating to electromagnetic compatibility.
CE mark affi xed: May 2017
Basis on which conformity is declared - The above equipment complies with the protection requirements of the EMC Directive.
Standards applied
2013/53/EU
ISO10133:2012
EN55014-1:2006
EN55014-2:1997+A2:2008
EN28846 :1993
Richard Bovill
Engineering Director
13.
PATENTS AND TRADEMARKS
WHALE® and GULPER® are registered trademarks of Munster Simms Engineering Limited, Bangor, Northern Ireland trading as Whale.
14.
WARRANTY
Possible Cause
No power to sensor
Fuse has blown
Dirt/debris has covered sensor
Pump is faulty
Sensor is faulty
Dirt/debris has covered sensor
Tank not emptying water
Incorrect wiring
Sensor is faulty
Pump is faulty
Recreational Craft Directive
Extra-low voltage DC Installation
EMC Emissions
EMC Immunity
Ignition Protection
Potential Solution
Check power supply, leads and connections
Replace fuse
Carefully remove the lid from the tank, and clean debris
from the sensor faces - Figure 3
Replace pump
Replace tank lid (see table Specifi cation for appropriate
service kit)
Carefully remove the lid from the tank, and clean debris
from the sensor faces - Figure 3
Check water supply level and pressure relief settings are
appropriate for the system
Check wiring Figures 1A / 1B
Replace tank lid (see table Specifi cation for appropriate
service kit)
Remove pump and check non-return valve and remove any
debris. Replace non-return valve if necessary
Discover other boat plumbing on our website.

Advertisement

loading

This manual is also suitable for:

Ak1006Ak1007Ak1008