Candy RO 496DWMC7/1-S Manual page 70

It is possible to modify the spin speed

without pausing the machine.
An over dosing of detergent can cause
excessive foaming. If the appliance
detects the presence of excessive foam,
it may exclude the spinning phase or
extend the duration of the program
and increase water consumption.
The machine is fitted with a special
electronic device, which prevents the
spin cycle should
unbalanced. This reduces the noise
and vibration in the machine and so
prolongs the life of your machine.
EASY IRON button
(Available on some programmes only)
This function allows you to minimize
creases as much as possible, eliminating
the intermediate spins or reducing the
intensity of the last one.
This option must be selected before
pressing the START/PAUSE button.
If the option is not compatible with the
selected programme then the option
indicator light first flashes and then
goes off.
CHILD LOCK
Pressing simultaneously

"TEMPERATURE
"SPIN SELECTION"
seconds, the machine allows you to lock
the keys. In this way, you can avoid
making accidental or unwanted changes
if a button on the display is pressed
accidently during a cycle.
The key lock can be simply cancelled by

pressing the two buttons simultaneously
again or turning off the appliance.
the load be
the buttons
SELECTION" and
for about
Digital display
The display's indicator system allows you to
be constantly informed about the status of
the machine.
1) WASH TEMPERATURE INDICATOR LIGHTS
This show the washing temperature of the
selected programme that can be changed
(where allowed) by the relevant button. If
you want carry out a cold wash all the
indicators must be off.
2) SPIN SPEED INDICATOR LIGHTS
This show the spin speed of the selected
programme, you can reduce or omit by the
relevant button.
3) DOOR LOCKED INDICATOR LIGHT
The indicator light is illuminated when the

door is fully closed.
Close the door BEFORE selecting the
START/PAUSE button.
When START/PAUSE is pressed on the

machine with the door closed, the
indicator will flash momentarily and then
illuminate.
3
If the door is not properly closed,
the light will continue to flash for
about 7 seconds, after which the
start command will be automatically
delete. In this case, close the door in
the proper
START/PAUSE button.
70
way and press the