Collection Tank; Caster - Craftsman CMXEVCVVBVCM12 Instruction Manual

ENGLISH
UNPACKING
WARNING:
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
1. Undo the latches 10
2. Lift the power head
5
tank .
3. Remove the contents from inside the
5

collection tank

contents as listed on page 3.
ASSEMBLY
Caster System Assembly
4. Turn the collection tank on its side and
insert the four caster feet
on the collection tank and tighten with the
pre-installed screws. Verify that the caster
feet 6 are mounted correctly. Do not over-
tighten screws. Fig. 1.
Fig. 1
GENERAL SET UP
5. Your vacuum comes ready for dry vacuum
cleaning. If the cartridge filter is not
installed, refer to page 9 for installation
instructions.
6. For wet vacuum cleaning, remove the
cartridge filter, and install the supplied foam
wet filter. See page 10 for the foam wet
filter installation instructions.
7. Place the power head back on the collection
tank and secure into place using the latches.
8. Insert the locking end of the hose
the vacuum port on the collection tank
and lock into place. Fig. 2.
6
VERIFY THAT THE
.
12 off the collection
; make sure you have all
6 into the slots
17
into
Fig. 2
9. Choose the desired accessory
and/or extension wands
the end of the hose
Fig. 3
10. Plug the power cord into the outlet.
Turn the motor on by flipping the on/off
switch
vacuuming. Fig. 4.
Fig. 4
WARNING:
COMPLETED VACUUMING, FLIP THE
ON/OFF SWITCH TO THE 'O' OFF POSITION
AND UNPLUG THE POWER CORD FROM THE
OUTLET. O = OFF
5
20 21 23
18
and insert onto
17 . Fig. 3.
16 to the 'I' ON position and begin
ONCE YOU HAVE
I = ON