Table of Contents
Advertisement
UUORESVUANGYS
DEAS 928 i UMCMUHGHUUUAOLTN LATE
RUETOUUSUEHRULY
ESO BCMA PTEL SH STOLE
1-3
SSC-C104/C108P
Mounting the Lens
| @Cmountlens
_ | 1) 9 mm (°/e inch) or less
@ CS mount lens
| 2)
4mm (°/s2 inch) or less
* Be sure to attach the lens mount cap when the lens is not mounted.
* Only lenses that are suitable for a '/s-inch CCD should be used with
this camera. If lenses for a ?/s-inch or '/2-inch CCD are used, the view
angle will be different.
g
The camera is supplied with a plug for inserting into the LENS connec-
tor on the side of the camera. When fitting an auto-iris lens, you will
need to replace the plug on the lens cable with the plug supplied.
Replace as follows:
@ Cover
@ Audio-iris cable
© Rib (if the cable is thick and the plug cover does not seat properly,
cut away this rib.)
© Lens plug
1 Remove the plug cover and solder the lens cable wires to the pins
on the plug supplied. The pin assignment is as follows:
i
ee
ea ee
@ Pini
Drive ()
1
Unscrew lens mount cap.
2 Screw in the lens.
.
3
First, replace the plug on the lens cable with the plug supplied with
the camera, Then, connect the camera cable plug to the LENS
socket.
:
4 Loosen the back focus LOCK screw. Adjust the back focus by
turning the C/CS adjustment ring in accordance with the type of lens
fitted (C-mount or CS-mount). Once adjusted, tighten the back focus
LOCK screw. (The factory setting is C-mount.)
When attaching a C-mount type lens, be sure to turn the C/C
adjustment ring fully in the "C" direction. When the C/CS adjustment
ring is set to "CS," mounting any lens with a mount projection of more
than 4 mm may damage the internal parts of the camera.
Advertisement
Table of Contents
