Advertisement
KEYPAD PROGRAMMING (PGM-670)
An optional programmer, the PGM-670, is available to assist with keypad programming of the
BHS-2000A. The PGM-760 requires no special installation: it is simply connected to the six pin header
directly above the ACP terminal block.
BASICS
In order to exit programming mode, remove the PGM-670 connector from the ACP. To program new
parameters you need to know two pieces of information: the location and the data. The Programming
Worksheet indicates the locations of all programmable items.
Using the Keypad: You will be using the 12 keys on the PGM-670. The digits 0-9 will retain their numeric
meaning. The
*
and # keys take on a special meaning:
»*" Key = DATA ENTRY AND LOCATION DISPLAY KEY - You will use this key to display a location
or to enter data.
Key = DATA DISPLAY KEY = You will use this key to display data at the current location.
Entering a Location: Using the keypad, enter a 1 to 3 digit number representing the location address. Press
the
key- The location is entered and its data content is displayed.
PROGRAMMING DATA: Using the keypad, enter a 1 to 3 digit number representing the new data
programmed for the present location. Press the
key. The new data is entered, the location is
automatically increment by one, and the new location address is displayed.
15
Advertisement
