Kenwood CD-223M Instruction Manual page 31

CD-223M/DPr-J3010 (En)
[Format]
System...Compact disc digital audio system
Laser.Semiconductor laser
[D/A Convertors]
D/A Conversion.... 1 Bit
Oversampling.8 fs (352.8 kHz)
[Audio]
Frequency response.
Signal to noise ratio .
Dynamic range .
Total harmonic distortion + noise
Channel separation.
Wow & flutter.
Output fevel/impedance
Fixed .
Digital output (DPF-J3010 only)
Optical .
.4 Hz ~ 20 kHz, * 0.5 dB
. More than 98 dB
. More than 96 dB
Less than 0.004% (at 1 kHz)
, More than 92 dB (at 1 kHz)
.Unmeasurable Limit
.2.o v/i kn
.-15 dBm ~ -21 dBm
[Wave length 660 nm)
[General]
Power consumption .10 W
Dimensions.W : 440 mm (17-5/16")
H : 173 mm (6-13/16")
D ; 479 mm (18-7/8")
Weight (Net).7.4 kg (16.3 lb)
1. KENWOOD follows a policy of continuous advancements in develooment. For this reason specifications m,
3
y be changed without notice.
2. The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modTications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Ciass B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interfer¬
ence to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to .-adio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna,
— Increase the separation between the equipment and receiver.
- - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- - Consult the dealer or an experienced radio / TV technician for help.
For the U.S.A.
CAUTION:
Use of controls or adjustments or pe'formance of procedures other than
those specified herein may result in hazardous radiation exposure.
1
-
1
1
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO, HACHIOJI-SHI.
TOKYO, JAPAN
-
1
1
1
|
In compliance with Federal Regulations, following are reproductions
of labels on, or inside the product relating to laser product safety.
1
1
1
KENWOOD CORP. CERTIFIES THIS EQUIPMENT CON-
FORMS TO DHHS REGULATIONS NO. 21 CFR 1040.10,
CHAPTER 1, SUBCHAPTER J.
1
1
1
1
1_ Location: Back Panel
1
_1
KENWOOD
For your records
Record the sor al number, fomid on the oac>-. of the ,,nt. m the spaces
designate':: or the weuanty care, and r me space cov oed bc:ow. Re's1
to *ne moael and scnal ru.
truers
vv'eneve'
you
ca l ucon
you' CiCa'nr
for
ivorma: or
o:
service o- ih s product.
al \umhe