Kenwood CD-223M Instruction Manual page 2

MM
SISSi.SCs.ft
CD-223 M/OPF-J 3010 (En)
SSWE85aS^353Ei
mg power
a, ^mamsxamusmasL.
! Caution : Read this section carefully to ensure safe operation.
z&msmzm?. m jbc ■
Units are designed for operation as follows.
U.S.A. and Canada.AC 120 V only
Australia.AC 240 V only
Europe and U.K..AC 230 V only
*Other countries.AC 110-120/220-240 Vswitchable
*AC voltage selection
The AC voltage selector switch on the rear panel is set to the voltage
that prevails in the area to which the unit is shipped. Before
connecting the power cord to your AC outlet, make sure that the
setting position of this switch matches your line voltage. If not, it must
be set to your voltage in accordance with the following direction.
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC voltage selector switch.
AC voltage selector switch
i _v. tarjxui
1 ©Oi O
: "Oi
"s
o c
Move switch leve' to match your line voltage with a
small screwdriver or other pointed tool,
For the United Kinadom
Factory fitted moulded mains plug
1. The mains plug contains a fuse. For replacement, use only a 13-Amp ASTA-approved (BS1362) fuse.
2. The fuse cover must be refitted when replacing the fuse in the moulded plug.
3. Do not cutoff the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach
a power point, then obtain an appropriate safety approved extension lead or adapter, or consult your dealer.
If nonetheless the mains plug is cut off. remove the fuse ana dispose of the plug immediately, to avoid a possible shock hazard by inadvertent
connection to the mains supply.
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Blue : Neutral
Brown : Live
Do not connect those leads to the earth terminal of a three-pin plug.
\flf0TW Precautions ! Caution : Read this section carefully to ensure safe operation.
wmm ■HiB»vwHaTiwiwqi*i wi»?
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
Ai
A
A
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
A
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SER¬
VICE PERSONNEL.
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDEDTO ALERTTHE
USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY
BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE
OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING
THE APPLIANCE.
REQUIREMENT BY NEDERLAND GAZETTE
Batteries arc supplied with this product. When
they empty, you should not throw away. In¬
stead, hand tnem in as small chemical waste.
The marking of products using lasers
(Except for some areas)
I
CLASS 1 I
LASER PRODUCT
g
The marking is located or the rear pane and says that the compc'ent
uses laser beams that have oeen classified as Class 1. If mea-s tea:
She unit s uliliz ry laser beams that a-e of a weaker class. I ne'e is no
danger of hazsidous isolation outside the uni