Prodew FogMist Block Installation Manual page 27

System Installation
11 Drill a 5/8in hole in the drain pan on each
side of the case at the highest point on
the employee side.
14 The 1/2in tubing should be 2-3in into
the bottom area of the case.
Cut tubing to length.
Repeat steps 13-14 for the 5/8in hole in
the other side of the case.
12 Locate the two sections of 1/2in
black tubing. These will be used
to protect the air and water lines.
15 Attach the 8mm tubing to the drip
pan port on the bottom of the
FogMist™ Block.
13 Run one section of 1/2in black
tubing from the blocks to the
5/8in hole.*
* Find the best,
least visible way
to route the tubing
from the Blocks
to the bottom of
the case.
16 Run the drain line down the side of the case,
ending a couple inches above the pan.
Be sure line won't drain onto product.
27