Prodew FogMist Block Installation Manual page 26

System Installation
5
Connect the filter to the port
labeled 'INLET' on the solenoid box
using black tubing.
8
Mount the timer behind the
display case (employee side).
TIMER
6
Connect the remaining black tubing
to the port labeled 'DRAIN' on the
solenoid box.
9
Plug the air compressor into the outlet
that is coming from the timer.
7
Run the drain line towards the floor drain
under the case. Strap the black tubing
to the existing drain lines using zip-ties.
Leave a 1in air gap
between the black tubing
and the drain to avoid
contamination.
10 Mount the FigMist™ Blocks as high
as possible without being obstructed
on each side of the display case.
26