Table of Contents
Advertisement
WARNING
First, make sure that the battery is sufficiently charged.
It is also very important that the device is level. Therefore, check whether the bubble level on the top
of the device indicates that the device is level and correct this if necessary.
Connect a suitable hose to the 'Empty Tank' connection piece and make sure that it is firmly attached.
Insert the other end of the hose into a container, such as a canister, which has enough capacity to
completely collect the fuel. Make sure that the end of the hose always remains in the container and is
not lying around openly.
At the beginning of this menu item, you will see this display in the LCD:
measure the filling level and on the other hand so that air can flow into the tank when the pumps are in
operation.
Now there is a scrolling text display with this content:
TIP
You will then see this display:
With 'Mode' a possibly switched on pump is also switched off and you cancel this menu item and
reach the next menu item.
Pumping out a full tank takes approx. four minutes.
Explosion hazard, fire hazard
Explosion of vapors, ignition of fuel.
•
During operation, the tank is partially ventilated.
•
Therefore, keep ignition sources away from the 'Tank Vent'
opening.
•
Fuel may be released during certain menu items. Keep ignition
sources away from a large area.
•
Observe all safety rules and regulations at all times.
If you want to pump out the tank, activate 'Up'. 'Mode' and 'Down' gets you
to the next menu item.
If you have selected the 'Pump out tank' function, this display appears for a
short moment while the tank is being ventilated. This pressure
compensation is necessary on the one hand so that the device can
If you are familiar with the scrolling text, you can speed it up by activating
'Mode'.
The pump is always switched off at the beginning and the device
continuously measures the level in the tank and displays it as a percentage
value. By activating 'Up' you switch on the pump.
The pump has been switched on here. Fuel is pumped out. The filling level
decreases. To stop pumping, you must actuate 'Down'. You can switch the
pump on again at any time.
When the tank is almost empty, this menu item is automatically terminated
and you will see this display.
50
Advertisement
Table of Contents
